Bit Switches
SM 69 D346
Fax Option
Type 5000
D346
(G3 reception)
0: After receiving each page
1: After receiving all pages
the machine receives it.
1: The machine prints the complete message after
the machine receives all the pages in the memory.
5/6
Not used
Do not change the factory settings.
7
Action when a fax SC has
occurred
0: Automatic reset
1: Fax unit stops
0: When the fax unit detects a fax SC code other
than SC1201 and SC1207, the fax unit
automatically resets itself.
1: When the fax unit detects any fax SC code, the
fax unit stops.
Cross Reference
Fax SC codes - See “Troubleshooting”
4.3.2 I-FAX SWITCHES
I-fax Switch 00 [SP No. 1-102-001]
FUNCTION COMMENTS
No
Original Width of TX
Attachment File
This setting sets the maximum size of the original
that the destination can receive. (Bits 3~7 are
reserved for future use or not used.)
0 A4
1 B4
2 A3
3-6 Reserved
7
Not used
0: Off (not selected), 1: On (selected)
If more than one of these three bits is set to “1”,
the larger size has priority. For example, if both Bit
2 and Bit 1 are set to “1” then the maximum size is
“A3” (Bit 2).
When mail is sent, there is no negotiation with the
receiving machine at the destination, so the
sending machine cannot make a selection for the
receiving capabilities (original width setting) of the
receiving machine. The original width selected
with this switch is used as the RX machine’s
original width setting, and the original is reduced to
To Next Page
Loading...
