Controller Options
SM 2-115 D009/D011/D012/D013/D091/D092
Installation
Stop all SDK applications with touching application lines.
Exit the UP mode, and then turn off the machine.
2. Turn the main switch off.
3. Remove the cover (
x1).
4. Remove the VM card from SD card slot 2 if installed.
5. Confirm that the RPCS Unit or Printer Unit SD card is in SD card Slot 1.
6. Put the original option SD card (Printer Enhance Option or Scanner Enhance Option)
in SD card slot 2.
7. Turn the main switch on.
8. Go into the SP mode and do SP5873-002 (Undo Exec).
9. Follow the messages on the operation panel to complete the procedure.
10. Turn the main switch off.
11. Remove the option SD card from Slot 2.
12. Turn the main switch on.
13. Go into the User Tools mode and confirm that undo was successful.
User Tools> System Settings> Administrator Tools> Firmware Version> Next
14. Turn the copier off again, then reattach the cover.
Important Notes about SD Cards
Here are some basic rules about merging applications on SD cards.
The data necessary for authentication is transferred with the application program to the
target SD card.
The SD card is the only evidence that the customer is licensed to use the application
program. The service technician may occasionally need to check the SD card and its
data to solve problems. SD cards must be stored in a safe location at the work site.
Once the merge is completed, the SD card from which the application was copied
cannot be used again, but the customer must keep the card to serve as proof of
purchase.
An SD card from which an application has been moved to another SD card can be
restored to full operation with SP5873-002 (Undo).
Before storing the card from which an application has been copied, label it carefully so
that you can identify it easily if you need to do the undo procedure later.
Application Merge
This machine has two SD card slots only. However, more than two optional applications are
supplied for this machine. Always keep SD card slot 2 vacant for servicing (except VM
Card Type F). Because of this, SD card merge is required if a customer wants to use many
applications.
To Next Page
Loading...
