Service Call Conditions
D009/D011/D012/D013/D091/D092 3-16 SM Appendix
-2 B
This SC is generated if the following condition occurs 3 consecutive times.
For the paper feed unit:
When the tray lowers, the tray lift sensor does not go off within 1.5 sec.
For the LCT:
When the main switch is turned on or when the LCT is set, if the end
fence is not in its position (home position sensor ON), the tray lift motor
stops.
If the upper limit does not go off for 1.5 seconds even the tray lift motor
turns on to lower the tray after the upper limit has been detected at
power on.
For the paper feed unit:
Defective tray lift motor or connector disconnection
Defective lift sensor or connector disconnection
For the LCT:
Defective stack transport clutch or connector disconnection
Defective tray motor or connector disconnection
Defective end fence home position sensor or connector disconnection
504 4th tray lift malfunction (optional paper feed unit)
-1 B
For the paper feed unit:
When the tray lift motor turns on, the upper limit is not detected within 10
seconds. If this condition occurs three consecutive times, the SC is
generated.
For the paper feed unit:
Defective tray lift motor or connector disconnection
Defective lift sensor or connector disconnection
-2 B
For the paper feed unit:
When the tray lift motor is turned on, the upper limit is not detected within 10
seconds.
If this condition occurs three consecutive times, the SC is generated.
Defective tray lift motor or connector disconnection
Defective lift sensor or connector disconnection
To Next Page
Loading...
