Ricoh D009 - Page 401

Service Call Conditions
SM Appendix 3-33 D009/D011/D012/D013/D091/D092
Appendix:
Service Call
Conditions
730 B
Finisher Tray 1 shift motor error
The shift roller HP sensor of the upper tray does not activate within the
prescribed time after the shift tray starts to move toward or away from the
home position.
The 1st detection failure issues a jam error, and the 2nd failure issues this
SC code.
 Shift tray HP sensor of the upper tray disconnected, defective
 Shift tray motor of the upper tray disconnected, defective
 Shift tray motor of the upper tray overloaded due to obstruction
740 B
Finisher corner stapler motor error
The 1st detection failure causes a jam error, and the 2nd failure causes this
SC code.
For the 2000/3000-sheet (booklet) finisher
 Staple movement is not finished after a certain time.
For the 1000-sheet finisher
 The stapler motor does not switch off within the prescribed time after
operating.
 The HP sensor of the staple unit does not detect the home position after
the staple unit moves to its home position.
 The HP sensor of the staple unit detects the home position after the
staple unit moves from its home position.
 Staple jam
 Motor overload
 Defective stapler motor