System SP Table-5
SM Appendix 4-99 D009/D011/D012/D013/D091/D092
Appendix:
Service
Program
Mode Tables
5801
Memory Clear
Resets NVRAM data to the default settings. Before executing any of these
SP codes, print an SMC Report.
IMPORTANT NOTE:
The following data stored in the NVRAM will not be saved on the SD Card
when performing an NVRAM Data Upload (SP5824):
• Total count categories (SP7-003-***Copy Counter)
• C/O P/O Counter (SP7-006-*** C/O, P/O Count Display)
• Duplex, A3/DLT/Over 420mm, Stapler and Scanner application
scanning counters(system settings).
• Engine SP Data
Therefore, whenever an NVRAM Upload/Download is performed, make
sure to print out the SP Data List before performing SP5801-001 (Memory
Clear) or SP5801-002 (Memory Clear: Engine).
001 All Clear Initializes items 2 to 15 below.
002 Engine Clear
Initializes all registration settings for the engine and
copy process settings.
003 SCS
Initializes default system settings, SCS (System
Control Service) settings, operation display
coordinates, and ROM update information.
004 IMH Memory Clear
Initializes the image file system.
(IMH: Image Memory Handler)
005 MCS
Initializes the automatic delete time setting for stored
documents.
(MCS: Memory Control Service)
006 Copier application Initializes all copier application settings.
007 Fax application
Initializes the fax reset time, job login ID, all TX/RX
settings, local storage file numbers, and off-hook
timer.
To Next Page
Loading...
