Main Machine Installation
SM 2-9 D009/D011/D012/D013/D091/D092
Installation
7. Close the front door.
8. Attach the correct emblem [4] and the cover [5] to the front door [6] of the machine, if
the emblem is not attached.
If you want to change the emblem that has been already attached, remove the
panel with a small screwdriver as shown [7], and then install the correct
emblem.
9. Attach the correct paper tray number and size decals to the paper trays [8].
Paper tray number and size decals are also used for the optional paper feed
unit or LCT. Keep these decals for use with these optional units.
10. Pull out the feeler [9] for the output tray full detection mechanism.
To Next Page
Loading...
