System SP Table-5
SM Appendix 4-151 D009/D011/D012/D013/D091/D092
Appendix:
Service
Program
Mode Tables
5967*
Switchover Permission Time
0: ON, 1: OFF
Enable and disable the document server. This is a security measure that
prevents image data from being left in the temporary area of the HDD. After
changing this setting, you must switch the main switch off and on to enable
the new setting.
5974*
Cherry Server
Selects which version of the Scan Router application program, "Light" or
"Full" (Professional) is installed.
[0 or 1 / 0 / - ]
0: Light
1: Full
5985
Device Setting
The NIC and USB support features are built into the GW controller. Use this
SP to enable and disable these features. In order to use the NIC and USB
functions built into the controller board, these SP codes must be set to "1".
001 On Board NIC
[0 to 2 / 0 / 1 /step]
0: Disable, 1: Enable, 2: Function limitation
When the "Function limitation" is set, "On board NIC" is
limited only for the NRS or LDAP/NT authentication.
Other network applications than @Remote or
LDAP/NT authentication are not available when
this SP is set to "2". Even though you can
change the initial settings of those network
applications, the settings do not work
002 On Board USB
[0 or 1 / 0 / 1/step]
0: Disable, 1: Enable
To Next Page
Loading...
