Connecting Procedure for Scanner Unit
B838 18 SM
40. Route and connect the power
supply cable [40] to CN310 on the
SIO (= x 4).
41. Secure two ground cables [41]
(BICU interface cable and power
supply cable) ( x 1; M3x6 blue
screw).
42. Route the heater relay cable [42] as shown and secure ground cable [43]
(= x 6, x 1; screw-round M4x8).
43. Reinstall the scanner rear frame
[44] ( x 8, x 2).
44. Connect the harness [45] to the
scanner HP sensor.
B838R926.PNG
B838R927.PNG
B838R160.WMF
[44]
[45]
To Next Page
Loading...
