Ricoh D009 - Page 918

Service Call Conditions
D017/D018/D019/D020 28 SM
board
2 A NVRAM read/write error  Replace the NVRAM
30 A NVRAM error
 Turn the machine power off/on
 If the error reoccurs, replace the controller
board
31 A  See SC991
859 B HDD data encryption error
Encryption of data on the hard disk failed.
8 B HDD check error  Format the HDD
6 B
Power loss during
encryption
 Format the HDD
10 B Data read/write error  See SC863 below
860 B HDD error 1
The hard disk connection is
not detected because it is
defective or has not been
formatted
 Cable between HDC and HDD loose or
defective
 HDD power connector loose or defective
 HDD not formatted
 HDD defective
 Replace the controller board
861 B HDD error 2
The HDD did not enter the
ready status within 30 sec.
after power on.
 Cable between HDC and HDD loose or
defective
 HDD power connector loose or defective
 HDD defective
 Replace the controller board
Rev. 09/2008