Punch Unit
SM 2-51 D009/D011/D012/D013/D091/D092
Installation
4. Remove the bracket [4] from the punch unit ( x 3).
5. Move the punch unit [5] along its rails into the finisher. Make sure that the pin engages
correctly at the front and rear.
6. Connect the cables [6] of the finisher to the connectors (CN601 and CN602) on the
punch unit board (
x 2, x 1).
The cables [6] are coiled and attached to the PCB.
7. Attach the slide drive unit [7] to the finisher and connect it to the punch unit (
x 2,
x 1). Push in the slide drive unit at
when you attach the screw .
8. Make sure that the punch unit moves freely and is not blocked by the screws.
To Next Page
Loading...
