Ricoh D009 - Page 999

Bit Switches
SM 109 D346
Fax Option
Type 5000
D346
0: OFF, 1: ON (enable) gatekeeper for IP-Fax.
5
IP Fax T30 bit signal reverse
0: LSB first, 1: MSB first
Reverses the T30 bit signal.
6
IP Fax max bit rate setting
0: Not affected, 1: Affected
When "0" is selected, the max bit rate does
not affect the value of the DIS/DCS.
When "1" is selected, the max bit rate affects
the value of the DIS/DCS.
7
IP Fax received telephone number
confirmation
0: No confirmation, 1:
Confirmation
When "0" is selected, fax data is received
without checking the telephone number.
When "1" is selected, fax data is received
only when confirming that the telephone
number from the sender matches the
registered telephone number in this
machine. If this confirmation fails, the line is
disconnected.
IP-Fax Switch 01
No. FUNCTION COMMENTS
Select IP FAX Delay Level
Bit3 Bit2 Bit1 Bit0 Setting
0 0 0 0 Level 0
0 0 0 1 Level 1
0 0 1 0 Level 2
0 0 1 1 Level 3
0-3
Raise the level by selecting a higher setting
if too many transmission errors are occurring
on the network.
If TCP/UDP is enabled on the network, raise
this setting on the T.30 machine. Increasing
the delay time allows the recovery of more
lost packets.
If only UDP is enabled, increase the number
of redundant packets.
Level 1~2: 3 Redundant packets
Level 3: 4 Redundant packets
4-7 IP Fax preamble wait time setting
Selects the preamble wait time.
[00 to 0f]
There are 16 values in this 4-bit binary