System Service Mode
D023/D025 8-412 SM Appendix
9912 [Target Angle] Ferrite Roller Paper Size Adjustment DFU
001 A3/DLT *ENG
[0 to 960 / 323 / 1 PULSE/step]
002 B4 *ENG
[0 to 960 / 381 / 1 PULSE/step]
003 A4/LT *ENG
[0 to 960 / 400 / 1 PULSE/step]
004 B5 *ENG
[0 to 960 / 498 / 1 PULSE/step]
005 A5/HLT *ENG
[0 to 960 / 525 / 1 PULSE/step]
006 B6 *ENG
[0 to 960 / 525 / 1 PULSE/step]
007 A6 *ENG
[0 to 960 / 525 / 1 PULSE/step]
9921
Page Correction Setting *CTL
Not used in this machine.
[0 to 9999999/ 0 / 1]
[Repeat Print Temp.Correction]
9965
These SPs are used for Preventing the fusing temperature overheating due to
a multiple printing job.
JOB Interval: Plain *ENG
[0 to 120 / 30 / 1 sec/step]
001
Specifies the job interval time in plain paper mode. The machine does not enter
the temperature correction mode for preventing the overheating for the time
specified with this SP.
JOB Interval: M-Thick *ENG
[0 to 120 / 30 / 1 sec/step]
002
Specifies the job interval time in middle thick paper mode. The machine does
not enter the temperature correction mode for preventing the overheating for
the time specified with this SP.
To Next Page
Loading...
