Bit Switches
SM 97 D393
Fax Option
Type C5000
(D393)
No FUNCTION COMMENTS
If there are more consecutive error lines in the
received page than the threshold, the machine will
send a negative response. The Low and High
threshold values depend on the sub-scan
resolution, and are as follows.
100 dpi 6(L) « 12(H)
200 dpi 12(L) « 24(H)
300 dpi 18(L) « 36(H)
0
G3 Burst error threshold
0: Low 1: High
400 dpi 24(L) « 48(H)
1
Acceptable total error line ratio
0: 5% 1: 10%
If the error line ratio for a page exceeds the
acceptable ratio, RTN will be sent to the other end.
2
Treatment of pages received
with errors during G3
reception
0: Deleted from memory
without printing
1: Printed
0: Pages received with errors are not printed.
3
Hang-up decision when a
negative code (RTN or PIN) is
received during G3 immediate
transmission
0: No hang-up, 1: Hang-up
0: The next page will be sent even if RTN or PIN is
received.
1: The machine will send DCN and hang up if it
receives RTN or PIN.
This bit is ignored for memory transmissions or if
ECM is being used.
4-7
Not used
Do not change the settings.
Communication Switch 03 [SP No. 1-104-004]
No FUNCTION COMMENTS
0-7 Maximum number of page 00 - FF (Hex) times.
To Next Page
Loading...
