Ricoh D025 - Page 1479

NCU Parameters
D393 138 SM
Address Function Unit Remarks
(parameter 15).
68054F
Time waited when a pause is
entered at the operation panel
SP2-103-017
(parameter 16). See
Note 3.
680550 DTMF tone on time
SP2-103-018
(parameter 17).
680551 DTMF tone off time
1 ms
SP2-103-019
(parameter 18).
680552
Tone attenuation level of DTMF
signals while dialing
-N x 0.5
–3.5 dBm
SP2-103-020
(parameter 19).
See Note 5.
680553
Tone attenuation value difference
between high frequency tone and
low frequency tone in DTMF
signals
-dBm x 0.5
SP2-103-021
(parameter 20).
The setting must be less
than –5dBm, and should
not exceed the setting at
680552h above.
See Note 5.
680554
PSTN: DTMF tone attenuation
level after dialling
-N x 0.5
–3.5 dBm
SP2-103-022
(parameter 21). See
Note 5.
680555
ISDN: DTMF tone attenuation
level after dialling
-dBm x 0.5 See Note 5
680556 Not used -
Do not change the
settings.
680557
Time between 68054Dh (NCU
parameter 14) and 68054Eh (NCU
parameter 15)
1 ms
This parameter takes
effect when the country
code is set to France.
680558 Not used - Do not change the