SC Tables
D023/D025 3-64 SM Appendix
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
Finisher error
The machine does not recognize the finisher, but recognizes the bridge
unit.
Defective connector
Defective harness
Incorrect installation
792 B
1. Check the connections between the finisher and the machine.
2. Install a new finisher.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
Upper limit switch error
The upper limit switch is pushed due to tray lift error or some problems.
Upper limit switch pulled up
Defective upper limit swtich
798
-1
B
Check the harness.
1. Check for blockage around the upper limit switch.
2. Replace the upper limit switch.
To Next Page
Loading...
