Ricoh D025 - Page 518

SC Tables
D023/D025 3-66 SM Appendix
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
Stack feed-out motor error
The stack feed-out HP sensor does not detect the home position of the
stack feed-out belt for a certain time after the stack feed-out belt has
moved to its home position.
The stack feed-out HP sensor does not turn off for a certain time after
the stack feed-out belt has moved from its home position.
The 1st detection failure causes a jam error, and the 2nd failure causes
this SC code.
 Defective stack feed-out HP sensor
 Overload on the stack feed-out motor
 Defective stack feed-out motor
 Defective main board
 Disconnected or defective harness
798
-4
B
1. Check or replace the harness.
2. Check for blockages in the stack feed-out mechanism.
3. Replace the stack feed-out HP sensor.
4. Replace the stack feed-out motor.
5. Replace the main board.