SC Tables
D023/D025 3-68 SM Appendix
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
Finisher corner stapler motor error
The 1st detection failure issues a jam error, and the 2nd failure issues
this SC code.
For 500-sheet finisher
The stapler HP sensor does not detect "ON"/"OFF" signal even the
stapler moves from the "OFF"/"ON" position for 0.6 seconds.
The stapler HP sensor does not detect "ON" when a stapling job is
commanded or the stapler moves.
Staple jam
Motor overload
Defective stapler motor
798
-6
B
1. Check the connections and cables for the components mentioned
above.
2. Replace the HP sensor and/or stapler motor
3. Replace the finisher main board.
To Next Page
Loading...
