Ricoh D025 - Page 610

System Service Mode
D023/D025 8-14 SM Appendix
High Temp. Correction *ENG
[0 to 15 / 5 / 1 deg/step]
004
Specifies the temperature correction for the heating roller. When the high
temperature condition (specified with SP1112-002) is detected, the value of
this SP is subtracted from the heating roller temperature.
005
Low Temp. Correction: Paper
Feed
*ENG
[0 to 15 / 6.5 / 0.1 deg/step]
006
High Temp. Correction: Paper
Feed
*ENG
[0 to 15 / 5 / 1 deg/step]
1113 [Stand-by Time]
001 After Ready *ENG
[0 to 60 / 20 / 1 sec/step]
After Recovery *ENG
[0 to 60 / 10 / 1 sec/step]
003
Specifies the time for keeping the target temperature after recovery
(SP1105-083) without any jobs.
004 After Job *ENG
[0 to 60 / 10 / 1 sec/step]
005 PressureTemp: After Ready *ENG
006 Pressure Temp: After Job *ENG
[0 to 160 / 100 / 1 deg/step]
008 ON/OFF Time Switch *ENG
[0 to 999 / 300 / 1 sec/step]