System Service Mode
SM Appendix 8-15 D023/D025
Appendix
SP Mode
Tables
1115 [Stand-by Idling]
Interval *ENG
[1 to 240 / 60 / 1 min/step]
001
Specifies the interval between idling during stand-by mode.
This idling during the stand-by mode prevents the roller deformation.
Idling Time *ENG
[1 to 60 / 2 / 0.1 sec/step]
002
Specifies the length of each idling operation during stand-by mode.
Idling Speed *ENG
[0 to 1 / 0 / 1 mm/sec/step]
003
1116 [Ends Temp. Correction]
Center Temp. 1: 226– ENG [-10 / 10 / 5 / 1 deg/step]
010
Specifies the temperature correction for the heating roller (center) when the
paper width is 226 mm or more.
The start time of this SP can be adjusted with SP1116-018.
Ends Temp. 1: 226– ENG
[-10 to 10 / 5 / 1 deg/step]
011
Specifies the temperature correction for the heating roller (ends) when the
paper width is 226 mm or more.
The start time of this SP can be adjusted with SP1116-018.
Center Temp. 2: 226– ENG
[-10 to 10 / 0 / 1 deg/step]
012
Specifies the temperature correction for the heating roller (center) when the
paper width is 226 mm or more.
The start time of this SP can be adjusted with SP1116-019.
To Next Page
Loading...
