System Service Mode
D023/D025 8-132 SM Appendix
[Special 3: Trailing Edge Correction] Special 3 Paper: Trailing Edge
Correction
2873
Adjusts the correction to the paper transfer roller current for the paper trailing
edge in each mode. SP2852 and SP2857 are multiplied by these SP values.
Thick 1 and Thick 2&Fine: 77 mm/sec
The paper trailing edge area can be adjusted with SP2874.
001 Paper Transfer: Thick 1: 1st Side *ENG
002 Paper Transfer: Thick 1: 2nd Side *ENG
003 Paper Transfer: Thick 1: 1st Side *ENG
005 Separation DC: Thick 1: 1st Side *ENG
006 Separation DC: Thick 1: 2nd Side *ENG
007 Separation DC: Plain: 1st Side *ENG
[0 to 400 / 100 / 5%/step]
[Special 3: Switch Timing: Trail. Edge]
2874
Adjusts the bias/voltage switch timing of the paper transfer roller/discharge
plate at the paper trailing edge between the erase margin area and the image
area.
Thick 1 and Thick 2&Fine: 77 mm/sec
001 Paper Transfer: Plain: 1st Side *ENG
002 Paper Transfer: Thick 1: 2nd Side *ENG
003 Paper Transfer: Thick 1: 1st Side *ENG
005 Separation DC: Thick 1: 1st Side *ENG
006 Separation DC: Thick 1: 2nd Side *ENG
007 Separation DC: Thick 1: 1st Side *ENG
[0 to 50 / 0 / 2 mm/step]
To Next Page
Loading...
