System Service Mode
SM Appendix 8-131 D023/D025
Appendix
SP Mode
Tables
005-008
Adjusts the correction to the discharge plate current at the paper leading edge
in each mode. SP2851 is multiplied by these SP values.
The paper leading edge area can be adjusted with SP2872.
005 Separation DC: Thick 1: 1st Side *ENG
006 Separation DC: Thick 1: 2nd Side *ENG
[0 to 400 / 100 / 5%/step]
007 Separation DC: Thick 1: 1st Side *ENG
[0 to 400 / 100 / 5%/step]
[Special 3: Switch Timing: Lead. Edge]
2872
Adjusts the bias/ voltage switch timing of the paper transfer roller/ discharge
plate at the paper leading edge between the erase margin area and the image
area.
Thick 1 and Thick 2&Fine: 77 mm/sec
001 Paper Transfer: Plain: 1st Side *ENG
002 Paper Transfer: Plain: 2nd Side *ENG
[0 to 50 / 0 / 2 mm/step]
003 Paper Transfer: Thick 1: 1st Side *ENG
005 Separation DC: Plain: 1st Side *ENG
006 Separation DC: Plain: 2nd Side *ENG
[0 to 50 / 0 / 2 mm/step]
007 Separation DC: Fine: 1st Page *ENG
008 Separation DC: Thick 1: 1st Side *ENG
[0 to 50 / 0 / 2 mm/step]
To Next Page
Loading...
