System Service Mode
D023/D025 8-294 SM Appendix
5888 [Personal Information Protect]
001 - *CTL
Selects the protection level for logs.
[0 to 1 / 0 / 1}
0: No authentication, or log protection
1: No authentication, Protected logs (only
an administrator can see the logs)
5894 [External Charge Unit Setting] Used with the external keycounter/coin
counter using the Optional 20 Interface Unit Type A 20-pin connection
001 Switch Charge Mode *ENG
[0 to 2 / 0 / 1/step]
Pattern 0 (SP5-894-001=0: Default setting) Default pattern which allows
separate counter for print, FAX (reception), B/W copy, and Full-color copy.
Pattern 1 (SP5-894-001=1) Separate counter for B/W and color is available
under this pattern. However, it is not possible to distinguish between Copier
and Printer outputs.
Pattern 2 (SP5-894-001=2) With this setting, it is possible to distinguish
between B/W and color outputs for both the Copier and Printer. However, it is
not possible to manage FAX reception documents.
5895
[Application Invalidation]
NOTE: For Fiery Installation, please refer to the D480/D479 Service Manual.
001
Printer
Scanner
*ENG
Off 0 (Default) On 1
5907 [Plug & Play Maker/Model Name]
Selects the brand name and the production name for Windows Plug & Play.
This information is stored in the NVRAM. If the NVRAM is defective, these
names should be registered again.
After selecting, press the "Original Type" key and "#" key at the same time.
When the setting is completed, the beeper sounds five times.
5913 [Switchover Permission Time]
002
Print Application Timer *CTL
[3 to 30 / 3 / 1 second /step]
Sets the amount of time to elapse while the machine is in standby mode (and
the operation panel keys have not been used) before another application can
gain control of the display.
Rev. 11/11
To Next Page
Loading...
