Ricoh G108 - Quitting SP Mode; Selecting a Service Program; Specifying a Setting

SERVICE PROGRAM MODE
G108 5-2 SM
Selecting a Service Program
1. Press the up-arrow key or the down-arrow key to select one of these menus:
• 1. Service
• 2. Engine
2. Press the Enter key.
3. Press the up-arrow key or the down-arrow key to select one of the submenus.
4. Press the Enter key.
5. Push the up-arrow key or the down-arrow key to select one of the service
programs.
6. Press the Enter key.
Specifying a Setting
1. Press the up-arrow key or the down-arrow key to select a setting.
2. To save the setting, press the Enter key.
3. To quit the program, press the Escape key.
Quitting SP Mode
1. Press the Escape key several times until the message "SYSTEM ver. x.xx" is
displayed.
2. Press the up-arrow key or the down-arrow key to select the following menu
item:
• 3. End
3. Press the Enter key.