Ricoh G108 - REPLACEMENT AND ADJUSTMENT

Exterior Covers
SM 1 G389
G389
Paper Feed
Unit
1. REPLACEMENT AND ADJUSTMENT
1.1 EXTERIOR COVERS
 Turn the power off and disconnect the printer before you remove parts of the printer.
Symbols:
: See or refer to,  : Screw,  : Connector, : Clip ring,  : E ring
1.1.1 TOP COVER AND SENSOR COVER
 When you reassemble, attach the top cover before you close the paper tray. The
link lever ( "Detailed Descriptions – Paper End Detection") is damaged if you
attach the top cover after you close the paper tray.
1. Remove the printer from the paper feed unit.
2. Paper tray [A]
 The paper tray is linked to the feeler of the paper end sensor ( "Detailed
Descriptions – Paper End Detection").
3. Ground plate [B] ( x 1)
4. Top cover [C] ( x 4)