REGISTRATION
3.14 REGISTRATION
3.14.1 LEADING EDGE REGISTRATION
Engine SP1-001 (Lead Edge Reg.) adjusts the
margin on the leading edge. When you specify a
greater value, the top margin becomes wider.
You can specify the values from -35 to +35.
When the value increases or decreases by 5 in
the SP, the margin changes by 0.7 mm. For example:
when you specify "+5,"
the margin changes by +0.7 mm; when you specify "-10," the margin changes
by -1.4 mm.
Default
±0.0 mm
Maximum +4.9 mm
Minimum -4.9 mm
Step 0.7 mm
NOTE: The diagrams below illustrate examples of adjustment results. Actual
results may be different from these examples.
To Next Page
Loading...
