Ricoh G108 - TRANSFER BELT

TRANSFER BELT
3.5 TRANSFER BELT
3.5.1 TRANSFER BELT UNIT
CAUTION: Do not touch the transfer belt. Use the grips [C] and [A] when you
remove or insert the transfer belt unit.
G108R929.WMF
[B]
[C]
[C]
[A]
1. Open the rear cover.
2. Transfer belt unit ( x 2) [B]
Necessary Setting
After replacing the transfer belt,
execute SP7-905-003 (PM Parts
Clear, Transfer Belt).
3.5.2 TRANSFER BELT SENSOR AND ID SENSOR
G108R923.WMF
[C]
[D]
[B]
[A]
1. OPC belt unit
2. Transfer belt unit
3. Erase lamp base [A]
( x 1,  x 2)
4. Transfer belt sensor [B]
( x 1)
5. ID sensor [C]
( x 1,  x 2)
Reassembling
Remove the paper tray from the printer when you reassemble. The paper tray
pushes up the lever [D] on the right end of the erase lamp base.
G108 3-10 SM