Ricoh G108 - ENGINE

SERVICE PROGRAM MODE
G108 5-10 SM
5.1.3 ENGINE
Abbreviations and keys
* : Saved in the NVRAM on the controller
FA : Factory setting (These settings may have been be adjusted before
shipment from the factory.)
DFU : Design/Factory Use (Do not change these settings.)
Possible Settings:
[Adjustable range / Default / Step] : Step is the amount of minimum change.
[Setting 1, Setting 2, Setting 3, ... ] : Boldface indicates the default.
Service SP or Engine SP:
Service SPx-xxx-xxx : Service SP ( 5.1.2)
Engine SPx-xxx-xxx : Engine SP ( 5.1.3)
SP1: Feed
Leading Edge Registration
[-35 ∼ +35 / 0 / 5 /step]
1001*
Adjusts the leading edge registration. When the value increases or decreases
by 5 in the SP, the margin changes by 0.7 mm. For example:  when you
specify "+5," the margin changes by +0.7 mm;  when you specify "-10," the
margin changes by -1.4 mm.
1002 Side-to-Side Registration
[-35 ∼ +35 / 0 / 5 /step]
1002 001* Paper Tray 1
1002 002* Paper Tray 2
1002 003* Paper Duplex
Adjusts the side-to-side registration. When the
value increases or decreases by 5 in the SP,
the margin changes by 0.5 mm. For example: 
when you specify "+5," the margin changes by
+0.5 mm;  when you specify "-10," the margin
changes by -1.0 mm.