CONTROLLER SELF-DIAGNOSTICS
G108 5-48 SM
5.4.2 DETAILED SELF-DIAGNOSTICS
The detailed self-diagnostics requires the loop-back connector (P/N: G0219350).
1. Turn off the main power switch. Then attach the loop-back connector to the
parallel interface.
2. Press and hold the Online key and the Enter key together.
3. Turn on the main power switch while you continue to press these two keys
simultaneously.
4. The machine begins the self-diagnostics. The machine will print a diagnostic
report when it finishes the self-diagnostics.
• Examine the diagnostics report and check the result.
• Use Engine SP7-832-001 (Diag. Result) to see the return code.
• For the error codes, see section 4.1.
To Next Page
Loading...
