Ricoh G108 - DEVELOPMENT

DEVELOPMENT
3.4 DEVELOPMENT
3.4.1 TONER END SENSOR
Emitter
G108R926.WMF
[A]
1. Top cover ( 3.1.1)
2. Right cover ( 3.1.2)
3. Development gear assembly ( 3.11.2)
4. Emitter of the toner end sensor [A] ( x 2,
 x 1)
Reassembling
Attach the upper end of the emitter with the
3x6 screw. Attach the lower with the 3x8
screw.
Receptor
1. Top cover ( 3.1.1)
2. Left cover ( 3.1.3)
3. Direct current unit ( 3.10.3)
4. High voltage unit ( 3.10.4)
5. Fusing unit
6. IOD cover ( 0)
7. High voltage unit base [A] ( x 1,  x 4)
NOTE: The connector is on the input
output device [B].
8. Receptor of the toner end sensor [C] ( x
2,  x 1)
G108R927.WMF
[B]
[C]
[A]
Reassembling
Attach the upper end of the emitter with the 3x6 screw. Attach the lower with the
3x8 screw.
G108 3-8 SM