Ricoh G108 - OHP Sensor, User Setting, and Printer Driver

PAPER TRAY UNIT
G108 6-36 SM
OHP Sensor, User Setting, and Printer Driver
Paper types are sensed or set by these components and programs:
• OHP sensor
• User setting (Menu > Paper Input > Paper Type)
• Printer driver interface on the pc workstation.
If these three items are not consistent, this machine sends a print job as follows:
1. Does not do the print job if the user setting and the printer driver are not the
same.
2. Gives priority to the OHP sensor under the following conditions (with one
exception [ 3]):
• The user settings and the printer driver are the same.
• The OHP sensor is not consistent with the two settings.
3. Gives priority to the user setting and the printer driver under the following
conditions:
• The user setting and the printer driver are set to glossy paper.
• The OHP sensor detects an OHP sheet.
NOTE: This is because the OHP sensor can incorrectly detect some types of
glossy paper as an OHP sheet.
4. Assumes that the paper type is glossy under the following conditions:
• The user setting and the printer driver specify the same paper type other than
OHP sheet.
• The printer driver sets duplex printing.
• The OHP sensor detects OHP sheets.
NOTE: When the printer driver sets simplex printing, the machine gives the
priority to the OHP sensor ( Item 2 above).
The table below overviews the information provided above.
OHP Sensor User Setting Printer Driver Processed as Remarks
OHP OHP OHP OHP No inconsistency
OHP Glossy Glossy Glossy  3
OHP
Not OHP
(= Printer driver)
Not OHP
(= User setting)
• Simplex: OHP
• Duplex: Glossy
 4
Not OHP OHP OHP Not OHP  2
Not OHP Glossy Glossy Glossy No inconsistency
Not OHP
Not OHP
(= Printer driver)
Not OHP
(= User setting)
Not OHP No inconsistency