Ricoh G108 - INSTALLATION PROCEDURE

INSTALLATION PROCEDURE
G108 1-4 SM
1.2 INSTALLATION PROCEDURE
1.2.1 INSTALLING THE PRINTER
See the Operating Instructions.
1.2.2 NECESSARY SETTINGS
For the installation procedure, see the Operating Instructions. After you install the
printer, alter the settings that are necessary for the service contract. When you
alter settings, use caution:
1. Enable Meter Charge (SP 5930 1) for any meter click counter contract. The
default is Off (disabled).
2. Double-check the contract before you change Counter Method (SP 5045). You
can change it only one time.
3. When you have enabled Meter Charge (SP 5930 1), specify Counter Method
(SP 5045) (developments/prints) in accordance with the contract ( 5.1.3).
The table lists the SP Mode settings related to service contracts.
Service Program Function
Meter Charge > On/Off
(SP5-930-001)
Enables or disables the Meter Charge. (Default: Off [Disabled])
When enabled:
• The Counter menu appears immediately after you push
the Menu key. The Counter Method (SP5-045) sets the
type of the counter.
• You can print the counter from the Counter menu.
When disabled:
• The Counter menu is not displayed.
• The total counter starts from 0 (zero).
Deleted
Counter Method (SP5-045) Specifies the count timing (developments/prints). (Default: 1
[Prints])
Telephone Number Setting >
Service (SP5-812-001)
Displays the telephone number of the service station. To type
the telephone number, see 5.1.5.
Telephone Number Setting >
Fax Telephone Number
SP5-812-002
Displays the fax number of the service station. The number is
printed on the counter list when the Meter Charge is enabled.
The user can send a fax message with the counter list. To type
the fax number, see 5.1.5.
⇒
Rev. 12/2004