IEEE 802.11B (WIRELESS LAN)
G108 6-58 SM
Procedure
Check the following:
• Check the LED indicator on the wireless LAN board.
• Check that IEEE 802.11b is specified in the following: Menu > Host Interface >
Network Setup > Frame Type.
• Check that the channel settings are correct.
• Check that the SSID and WEP are correct.
In addition, check the following when the infrastructure mode is used:
• Check that the MAC address is correct.
• Check the communication status.
If the communication condition is not good, try the following:
• Move the printer closer to the access point.
• Check for anything that might interfere with wireless communication.
• If the problem is not solved, try changing the channel.
To Next Page
Loading...
