Ricoh G108 - Charge Roller and Cleaning Roller

OPC
3.3.3 CHARGE ROLLER AND CLEANING ROLLER
NOTE: The Charge Roller and Cleaning Roller are replaced as part of the OPC
Belt Unit. These parts are not available as spare parts. If disassembled,
reassembly can be difficult.
1. OPC belt unit ( 3.3.1)
2. Release the locks [A][B].
3. Gripping the “hand-hold” located on the cover,
pull to remove the cover and assembly. The
Charge roller and cleaning roller assembly are
located in the cover [C]
[A]
G108R937.WMF
[C]
[B]
4. Remove the cover [C] left holder
[D] and right holder [E] with the
charge roller and the cleaning
roller
5. Remove cleaning roller gear [F]
6. Remove cleaning roller idle gear
[H] ( x 1)
7. Left holder
8. Right holder with drive gear [I]
NOTE: 1) Be certain to protect
the OPC Belt from excessive exposure to light.
G108R938.W
[G]
[I]
[H]
[E]
[F]
[D]
MF
[C]
2) If replacement of either the Charge Roller and/or Cleaning Roller
becomes necessary, you must replace the entire OPC Belt Unit.
G108 3-6 SM