Ricoh MP C307

3.System Maintenance
50
Update method Features Control
panel
firmware
Applications
first time.
Installation/update
from Application Site
Installation and Updating of applications and firmware
update can be done from Application Site. When
administrator authentication is enabled, an administrator
privilege is required to start Application Site. If you log in
to the operation panel service mode, however, you can use
it with CE privilege.
Yes*
1
Yes
*1 Update can only be done by using a package file.
The following three methods can be used for updating the firmware.
• Update from an SD card (recovery mode)
• Package update
• Installation/update from Application Site
The following four methods can be used for updating an application.
• Installation/update from an SD card
• Package update
• Installation/update from the eDC Server
• Installation/update from Application Site
Installation/update from an SD card
Updating the Smart Operation Panel Firmware
Enter the recovery mode to update the firmware of the Smart Operation Panel.
• When [Quick] is selected for [Screen Startup Mode], the control panel cannot enter the
recovery mode. Change the startup mode to [Normal]. When update is completed, restore
the startup mode setting because the setting affects startup time.
• Shut down the MFP with [Normal] selected for [Screen Startup Mode], or shut it down
using the special shutdown procedure used for maintenance.
• If [Prohibit] is selected for [Update Firmware] in [System Settings], the machine cannot
enter Recovery mode. Ask the administrator of the MFP to change the setting.
Creating an SD card for firmware update
1.
Download the update module “Cheetah System” from the Firmware Download Center.
2. Execute the downloaded file.
A file named “part number + suffix.zip” will be created.