4.Service Tables
57
0-
2
Not used Do not change these settings.
3 Printing dedicated tx
parameters on Quick/Speed
Dial Lists
0: Disabled
1: Enabled
1: Each Quick/Speed dial number on the list is printed with the
dedicated tx parameters (10 bytes each).
The first 10 bytes of data are the programmed dedicated tx parameters;
34 bytes of data are printed (the other 24 bytes have no use for service
technicians).
4-
7
Not used Do not change these settings.
System Switch 05 - Not used (Do not change the factory settings.)
System Switch 06 - Not used (Do not change the factory settings.)
System Switch 07 - Not used (Do not change the factory settings.)
System Switch 08 - Not used (Do not change the factory settings.)
System Switch 09 (SP No. 1-101-010)
No Function Comments
0 Addition of image data from
confidential transmissions on the
transmission result report
0: Disabled 1: Enabled
If this feature is enabled, the top half of the first page of
confidential messages will be printed on transmission result
reports.
1 Print timing of communication reports
on the Journal when no image data was
exchanged.
0: After DCS/NSS communication
(default),
1: After polling
0: The Journal is printed only when image data is sent.
1: The Journal is printed when any data is sent.
2 Automatic error report printout
0: Disabled 1: Enabled
0: Error reports will not be printed.
1: Error reports will be printed automatically after failed
communications.
3 Printing of the error code on the error
report
0: No 1: Yes
1: Error codes are printed on the error reports.
This can be used for detecting an error which occurs rarely.
4 Not used Do not change this setting.
5 Power failure report
0: Disabled
1: Enabled (default)
1: A power failure report will be automatically printed after the
power is switched on if a fax message disappeared from the
memory when the power was turned off last.
NOTE: If "0" is selected, no reports are printed and no one
To Next Page
Loading...
