4.Service Tables
72
0* Length reduction of received data
0: Disabled
1: Enabled
0: Incoming pages are printed without length reduction.
(Page separation threshold: Printer Switch 03, bits 4 to 7)
1: Incoming page length is reduced when printing.
(Maximum reducible length: Printer Switches 04, bits 0 to 4)
1-
3
Not used Do not change the settings
4
to
7
Page separation setting when sub scan
compression is forbidden
00-0F (0-15 mm: Hex)
Default: 6 mm
Page separation threshold (with reduction disabled with
switch 03-0 above).
For example, if this setting is set to "10", and A4 is the
selected paper size:
If the received document is 10 mm or less longer than A4,
then the 10 mm are cut and only 1 page prints.
If the received document is 10 mm longer than A4, then the
document is split into 2 pages.
* This setting can be used for the client-side machine which has no FCU.
Printer Switch 04 (SP No. 1-103-005)
No Function Comments
0
to
4
Maximum reducible length when length reduction is enabled with switch 03-0 above.
[Maximum reducible length] = [Paper length] + (N x 5mm)
"N" is the decimal value of the binary setting of bits 0 to 4.
Bit 4 Bit 3 Bit 2 Bit 1 Bit 0 Setting
0 0 0 0 0 0 mm
0 0 0 0 1 5 mm
0 0 1 0 0 20 mm
1 1 1 1 1 155 mm
For A5 sideways and B5 sideways paper
[Maximum reducible length] = [Paper length] + 0.75 x (N x 5mm)
5
6
Length of the duplicated image on the next page, when page separation has taken place.
Bit 6 Bit 5 Setting
0 0 4 mm
0 1 10 mm
1 0 15 mm
1 1 Not used
7 Not used. Do not change the setting.
Printer Switch 05 - Not used (do not change the settings)
Printer Switch 06 (SP No. 1-103-007)