Ricoh MP C307

4.Service Tables
94
1: Not answer not registered for the machine and send a refusal message.
5 ECM communication setting
0: No limit for image compression
1: Limit for image compression
0: This does not limit the type of the image compression with ECM
communication.
1: When the other end machine is Ciscco, this permits the image
compression other than JBIG or MMR with ECM communication.
6-7 Not used Do not change these settings.
IP Fax Switch 03 (SP No. 1-111-004)
No. Function Comments
0 Effective field limitation for G3 standard
function information
0: OFF, 1: 4byte (DIS)
Limits the effective field for standard G3 function
information.
1 Switching between G3 standard and G3
non standard
0: Enable switching
1: G3 standard only
Enables/disables switching between G3 standard and G3
non-standard.
2 Not used Do not change this setting.
3 ECM frame size selection at transmitting
0: 256byte, 1: 64byte
Selects the ECM frame size for sending.
4 DIS detection times for echo prevention
0: 1 time, 1: 2 times
Sets the number of times for DIS to detect echoes.
5 CTC transmission selection
0: PPRx1
1: PPRx4
When "0" is selected, the transmission condition is decided
by error frame numbers.
When "1" is selected, the transmission condition is based
on the ITU-T method.
6 Shift down setting at receiving negative
code
0: OFF, 1: ON
Selects whether to shift down when negative codes are
received.
7 Not used Do not change this setting.
IP Fax Switch 04 (SP No. 1-111-005)
No. Function Comments
0-3 TCF error threshold Sets the TCF error threshold level. [00 to 0f]
The default is "1111" (0fH).
4-7 Not used Do not change these settings.
IP Fax Switch 05 (SP No. 1-111-006)
No. Function Comments