Ricoh MP C307

Image Adjustment
194
2 Middle (Middle
ID)
(K, C, M, and
Y)
Adjust the offset value so that the density of level 7 matches
that of level 7 on the C-5Y chart.
3 Shadow (High
ID)
(K, C, M, and
Y)
Adjust the offset value so that the density of level 11
matches that of level 11 on the C-5Y chart.
4 Highlight (Low
ID)
(K, C, M, and
Y)
Adjust the offset value so that dirty background does not
show on the copy and the density of level 3 is slightly
lighter than that of level 3 on the C-5Y chart.
5 K Highlight
(Low ID) (C,M,
and Y)
<on the full
color copy>
Adjust the offset value so that the color balance of black
scale levels 3 through 5 in the copy is seen as gray (no C,
M, or Y should be visible). If the black scale contains C, M,
or Y, do steps 1 to 4 again.
- Photo Mode, Single Color -
Item to
Adjust
Level on the C-5Y chart Adjustment Standard
1 ID max: (K)
Adjust the offset value so that the density of level 13 matches
that of level 13 on the C-5Y chart.
2 Middle
(Middle ID)
(K)
Adjust the offset value so that the density of level 7 matches
that of level 7 on the C-5Y chart.
3 Shadow (High
ID) (K)
Adjust the offset value so that the density of level 11 matches
that of level 11 on the C-5Y chart.
4 Highlight
(Low ID) (K)
Adjust the offset value so that dirty background does not
show on the copy and the density of level 3 is slightly lighter
than that of level 3 on the C-5Y chart.
- Text (Letter) Mode, Full Color -
Item to
Adjust
Level on the C-5Y chart
(K)
Adjustment Standard
1 ID max: (K, C,
M, and Y)
Adjust the offset value so that the density of level 13 matches
that of level 13 on the C-5Y chart.
2 Middle
(Middle ID)
(K, C, M, and
Adjust the offset value so that the density of level 7 matches
that of level 7 on the C-5Y chart.