Image Adjustment
198
4. Rotate the knob(s) shown in the diagram [A] to [D] at 90 degree intervals until the SP value for the
affected color(s) is within ±5 (target: 0).
• There are two knobs on each of the two LD units. A click is felt every 90 degree rotation.
• Turning the knob clockwise by 90 degrees changes the SP value by -1.
• Turning the knob counter-clockwise by 90 degrees changes the SP value by +1.
• Example:
SP value for magenta in Step 4 was “+6” Turn knob [C] 6 clicks (1 1/2 rotations) clockwise.
• SP value for yellow in Step 4 was “-7” Turn knob [D] 7 clicks (1 3/4 rotations)
counter-clockwise.
5. Reattach all parts that you removed in the above steps.
• Do not touch the LD units while installing the Paper Exit Tray. Otherwise, the LD unit may
move, and you may have to adjust the color skew again.
To Next Page
Loading...
