Ricoh OR-C1 - Page 454

No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
798
-04
B
Stack feed-out motor error (D585)
The machine does not detect a correct signal from the stack feed-out HP sensor
while the stack feed-out motor is operating. The 1st detection failure issues a jam
error, and the 2nd failure issues this SC code.
• Defective stack feed-out HP sensor
•
Overload on the stack feed-out motor
•
Defective stack feed-out motor
• Defective main board
• Disconnected or defective harness
1. Check or replace the harness.
2. Check for blockages in the stack feed-out mechanism.
3.
Replace the stack feed-out HP sensor.
4. Replace the stack feed-out motor.
5. Replace the main board.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
798
-05
B
Positioning roller arm motor error (D585)
The machine does not detect a correct signal from the positioning roller HP sensor
while the positioning roller arm motor is operating. The 1
st
detection failure issues
a jam error, and the 2
nd
failure issues this SC code.
• Disconnected or defective harness
• Overload on the positioning roller arm motor
•
Defective positioning roller arm motor
• Defective positioning roller HP sensor
1. Check or replace the harness.
2. Check for blockages in the positioning roller arm mechanism.
3.
Replace the positioning roller arm motor.
4. Replace the positioning roller HP sensor.
3. Appendix: Service Call Conditions
96
3