Solutions: If printing an original including both solid-fill and half-tone parts on the
same page
1. Can you rotate the original by 90 or 180 degrees?
• A: Rotation by 90 degrees
• B: Rotation by 180 degrees
Yes Rotate the original by 90 or 180 degrees.
No Proceed to Step 3.
2. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
3. If the paper is not registered as custom paper, register the brand of the paper.
4. In [Detailed settings] for the custom paper you are using, select 1231: [Print Speed], and
then set the value in the following corresponding settings to [Middle].
• 1231-01: Print Speed: BW/FC/FCS: BW/FC/FCS
• 1231-02: Print Speed: FCS: Clear/Special
• 1231-03: Print Speed: FCS: White
• 1231-04: Print Speed: FCS: Metallic
• 1231-06: Print Speed: S: Clear/Special
• 1231-07: Print Speed: S: White
• 1231-08: Print Speed: S: Metallic
• 1231-10: Print Speed: BW/FC/FCS: Fuser Setting HQ: BW/FC/FCS
• 1231-11: Print Speed: FCS: Fuser Setting HQ: Clear/Special
Bands
147
To Next Page
Loading...
