• It is recommended to feed the paper by separating the jobs into the following number of sheets
(because the interval of automatic polishing execution is close to this number of sheets).
• Frequently: 1 job = up to 2000 sheets
• More Frequently: 1 job = up to 600 sheets
• Most Frequently: 1 job = up to 400 sheets
If the paper type for fusing nip width is set to "other than envelopes"
1. Select the paper from the Master paper, change the paper name to "(Paper Name)
Refreshing", and register it as custom paper.
2. In [Detailed settings] for custom paper, select 1241-01: [Fusing Nip Width Adjustment:
Other than Envelope], and then change it to "Nip Width 2".
3. Select 1244: [Fusing Pressure Roller On Before Fusing] to [On].
4. In [Detailed settings] for custom paper, use the following settings to increase the margin
width by 1 mm at the leading edge of the image.
• 1239-01: Margin: BW/FC/FCS/S: Leading Edge
• 1239-03: Margin: FCS: Leading Edge: Clear/Special
• 1239-04: Margin: FCS: Leading Edge: White
• 1239-05: Margin: FCS: Leading Edge: Metallic
5. Select 1232 [Fusing Temperature], and then check the temperature setting or the fusing
heat roller.
• 1232-01: Fusing Temperature: BW/FC/FCS: Heat Roller Temp
• 1232-06: Fusing Temperature: FCS: Heat Roller Temp: Clear/Special
• 1232-07: Fusing Temperature: FCS: Heat Roller Temp: White
• 1232-08: Fusing Temperature: FCS: Heat Roller Temp: Metallic
• 1232-26: Fusing Temperature: S: Heat Roller Temp: Clear/Special
• 1232-27: Fusing Temperature: S: Heat Roller Temp: White
• 1232-28: Fusing Temperature: S: Heat Roller Temp: Metallic
• 1232-46: Fusing Temperature: BW/FC/FCS: Fuser Setting HQ: Heat Roller Temp
• 1232-51: Fusing Temperature: FCS: Fuser Setting HQ: Heat Roller Temp: Clear/Special
• 1232-52: Fusing Temperature: FCS: Fuser Setting HQ: Heat Roller Temp: White
• 1232-53: Fusing Temperature: FCS: Fuser Setting HQ: Heat Roller Temp: Metallic
• 1232-71: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: Clear/Special
• 1232-72: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: White
• 1232-73: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: Metallic
5. Image Quality Problem: Lines/Streaks
168
To Next Page
Loading...
