2. In [Detailed settings] for custom paper, select 1341: [Motor Speed] and then increase the
value for the applicable setting by 0.1%.
If this problem occurs with single-sided printing 1341-09: Motor Speed: Speed Adjustment:
Paper Output Roller
If this problem occurs with duplex printing 1341-10: Motor Speed: Speed Adjustment:
Switchback: Entrance Roller
If this problem occurs only with turned-over
paper delivery
1341-11: Motor Speed: Speed Adjustment:
Switchback: Exit Roller
3. Print the image. Has the problem been resolved?
Yes Finished!
No Start over from Step 2.
If the problem persists even after decreasing the values by up to 1.0% in total, there
is a possibility of another cause, so restore the previous settings and see other
troubleshooting.
Solution: Adjusting the Decurler Setting
(a) Scratches or Streaks on the Front of the Paper / Paper Creases or Bent Corners
1. If the paper is not registered as custom paper, register the brand of the paper.
2. In [Detailed settings] for custom paper, check the decurling level in 1321-01: [Correction
Mode].
3. In accordance with the decurling level, decrease the applicable setting's value by 0.5%.
If set to "Correction Off" 1321-02: Correct Paper Curl: Speed Adjustment: Decurler:
Correction Off
If set to "Correction
Weak"
1321-03: Correct Paper Curl: Speed Adjustment: Decurler:
Correction Weak
If set to "Correction
Strong"
1321-04: Correct Paper Curl: Speed Adjustment: Decurler:
Correction Strong
4. Print the image. Has the problem been resolved?
Yes Finished!
8. Troubles Related to Paper Feeding and Delivery (Main)
228
To Next Page
Loading...
