• 1214-15: Paper Transfer Output: S: Side 1: Metallic
• 1214-17: Paper Transfer Output: S: Side 2: Clear/Special
• 1214-18: Paper Transfer Output: S: Side 2: White
• 1214-19: Paper Transfer Output: S: Side 2: Metallic
(d) Adjust the image (intermediate) transfer output.
1. Register the paper in the custom paper profile.
In [Detailed settings] for the custom paper you are using, select 1212: [Image Transfer Output],
and then decrease the value in the following corresponding settings by 1.
1212-01: Image Transfer Output: BW: Black
1212-02: Image Transfer Output: FC/FCS: Black
1212-03: Image Transfer Output: FC/FCS: Cyan
1212-04: Image Transfer Output: FC/FCS: Magenta
1212-05: Image Transfer Output: FC/FCS: Yellow
1212-06: Image Transfer Output: FC/FCS: Clear/Special
1212-07: Image Transfer Output: FC/FCS: White
1212-08: Image Transfer Output: FC/FCS: Metallic
1212-10: Image Transfer Output: S: Clear/Special
1212-11: Image Transfer Output: S: White
1212-12: Image Transfer Output: S: Metallic
• Decreasing the image transfer output may result in an overall slightly fainter solid-fill image density.
(e) Increase the amount of toner adhesion.
1. In [Detailed settings] for custom paper, select 1201: [Maximum Image Density], and then
increase value.
1201-01: Maximum Image Density: Black
1201-02: Maximum Image Density: Cyan
1201-03: Maximum Image Density: Magenta
1201-04: Maximum Image Density: Yellow
1201-05: Maximum Image Density: Clear/Special
1201-06: Maximum Image Density: White
1201-07: Maximum Image Density: Metallic
4. Image Quality Problem: Full Page
78
To Next Page
Loading...
