Ricoh Pro C7500 - Page 93

• The toner does not come off even if it is rubbed by the cloth for cleaning the contact
glass.
Yes Finished!
No Change the print speed to "Low". Go to "(b) Changing the fusing temperature (If
[Print Speed] is set to [Low])".
(b) Changing the fusing temperature (If [Print Speed] is set to [Low])
1. Select 1232: [Fusing Temperature], and then decrease the value in the following
corresponding settings by 20°C.
2. Set the value in the following corresponding settings to 0°C.
Productivity Priority
• 1232-02: Fusing Temperature: BW/FC/FCS: Correct Temp: Initial Feed
• 1232-10: Fusing Temperature: FCS: Correct Temp: Initial Feed: Clear/Special
• 1232-11: Fusing Temperature: FCS: Correct Temp: Initial Feed: White
• 1232-12: Fusing Temperature: FCS: Correct Temp: Initial Feed: Metallic
• 1232-30: Fusing Temperature: S: Correct Temp: Initial Feed: Clear/Special
• 1232-31: Fusing Temperature: S: Correct Temp: Initial Feed: White
• 1232-32: Fusing Temperature: S: Correct Temp: Initial Feed: Metallic
High Quality
• 1232-47: Fusing Temperature: BW/FC/FCS: Fuser Setting HQ: Correct Temp: Initial Feed
• 1232-55: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Initial Feed: Clear/
Special
• 1232-56: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Initial Feed: White
• 1232-57: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Initial Feed: Metallic
• 1232-75: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Initial Feed: Clear/Special
• 1232-76: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Initial Feed: White
• 1232-77: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Initial Feed: Metallic
3. Set the value in the following corresponding settings to 5°C.
Productivity Priority
• 1232-03: Fusing Temperature: BW/FC/FCS: Correct Temp: Pre-Feed
• 1232-14: Fusing Temperature: FCS: Correct Temp: Pre-Feed: Clear/Special
• 1232-15: Fusing Temperature: FCS: Correct Temp: Pre-Feed: White
• 1232-16: Fusing Temperature: FCS: Correct Temp: Pre-Feed: Metallic
• 1232-34: Fusing Temperature: S: Correct Temp: Pre-Feed: Clear/Special
Uneven Density
91