Ricoh Pro C7500 - Page 92

When decreasing the
print speed to [Middle]
Go to "(a) Changing the fusing temperature (If [Print Speed] is set to
[Middle])".
When decreasing the
print speed to [Low]
Go to "(b) Changing the fusing temperature (If [Print Speed] is set to
[Low])".
(a) Changing the fusing temperature (If [Print Speed] is set to [Middle])
1. Select 1232: [Fusing Temperature], and then decrease the value in the following
corresponding settings by 5°C.
Productivity Priority
• 1232-01: Fusing Temperature: BW/FC/FCS: Heat Roller Temp
• 1232-06: Fusing Temperature: FCS: Heat Roller Temp: Clear/Special
• 1232-07: Fusing Temperature: FCS: Heat Roller Temp: White
• 1232-08: Fusing Temperature: FCS: Heat Roller Temp: Metallic
• 1232-26: Fusing Temperature: S: Heat Roller Temp: Clear/Special
• 1232-27: Fusing Temperature: S: Heat Roller Temp: White
• 1232-28: Fusing Temperature: S: Heat Roller Temp: Metallic
High Quality
• 1232-46: Fusing Temperature: BW/FC/FCS: Fuser Setting HQ: Heat Roller Temp
• 1232-51: Fusing Temperature: FCS: Fuser Setting HQ: Heat Roller Temp: Clear/Special
• 1232-52: Fusing Temperature: FCS: Fuser Setting HQ: Heat Roller Temp: White
• 1232-53: Fusing Temperature: FCS: Fuser Setting HQ: Heat Roller Temp: Metallic
• 1232-71: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: Clear/Special
• 1232-72: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: White
• 1232-73: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: Metallic
2. Print 10 or more A3 sheets. Has the problem been resolved?
Yes Proceed to Step 3.
No Start over from Step 1.
3. Is the toner fusibility within the permissible range?
• The required level of fusibility is as follows.
• The printed image does not come off.
• The toner does not come off even if it is lightly rubbed by a nail.
4. Image Quality Problem: Full Page
90