8. PARAMETER DESCRIPTION
IMR02C15-E4
8-5
ダミー
Manipulated output value (MV2) monitor [cool-side]
The Manipulated output value (MV2) of cool-side is displayed on the SV
display.
Display range Factory set value
Within output limiter range
When the control method is Heat/Cool PID action, the Manipulated
output value (MV2) monitor is displayed.
To hide Manipulated output value (MV2) monitor [cool-side], set “No
display” to Monitor selection (no display) in the Engineering mode
(P. 8-58).
Related parameters
Engineering mode:
• Monitor selection (no display) (P. 8-58)
Remaining time monitor
Displays the elapsed time of timer operation.
Timer function 1:
Shows the time remaining in RUN (control RUN) during the timer time
operation.
Timer function 2:
Shows the time remaining in STOP (control STOP) during the timer time
operation.
Timer function 3 and Timer function 4:
Shows each time remaining in the order of Set values from SV1, SV2, SV3,
and SV4 during the timer time operation.
Display range Factory set value
0 minutes 00 seconds to 99 minutes 59 seconds
or 0 hours 00 minutes to 99 hours 59 minutes
The factory preset is “Min.: Sec.”.
Related parameters
Engineering mode:
• Monitor selection (no display) (P. 8-58)
MV2
TIME
To Next Page
Loading...
