RKC INSTRUMENT RB Series - Removal Procedures

2. MOUNTING
IMR02C15-E4
2-9
 Removal procedures
1. Turn the power OFF.
2. Remove the wiring.
3. Loosen the screw of the mounting bracket. (Fig. 2.11)
4. Lift the latch of the mounting bracket (), then pull
the mounting bracket (), to remove it from the case.
(Fig. 2.11)
5. The other mounting bracket should be removed in the
same way as described in 3 and 4.
6. Pull out the instrument from the mounting cutout while
holding the front panel frame of this instrument.
(Fig. 2.12)
Use long-nose pliers to remove mounting brackets from the
instrument that is installed in a narrow place or installed tightly in a
vertical position.


Fig. 2.11
Loosen the screw
Panel
Front panel frame
Pull out
Fig. 2.12