RKC INSTRUMENT RB Series - Changing Set Value

4. BASIC OPERATION
4-4 IMR02C15-E4
4.2 Changing Set Value
• The flashing digit indicates which digit can be set. Press key to go to a different digit. Every
time the shift key is pressed, the flashing digit moves as follows.
8
Flashing
SV1
888
R/SR/SR/S
R/S
• The following is also available when changing the set value.
Increase SV from 199 °C to 200 °C:
1. Press the key to flash the ones place
(first digit from the right).
2. Press the key to change to 0.
The display changes to 200.
Decrease SV from 200 °C to 190 °C:
1. Press the key to flash the tens place.
2. Press the key to change to 9.
The display changes to 190.
Decrease SV from 200 °C to –100 °C:
1. Press the key to flash the hundreds place.
2. Press the key (three times) to change to −1.
The display changes to −100.
• To store a new value for the parameter, always press the key. The display changes to the
next parameter and the new value will be stored.
A new value will not be stored without pressing key after the new value is displayed on
the display.
After a new value has been displayed by using the and keys, the key must be
pressed within 1 minute, or the new value is not stored and the display will return to the
Monitor display mode.
R/S
SET
R/S
R/S
R/S
28$
0199
SV1
28
$
0200
SV1
Flashing Flashing
28$
0200
SV1
28
$
0190
SV1
Flashing Flashing
28$
0200
SV1
28
$
-100
SV1
Flashing Flashing
SET
SET