SETUP
PROCEDURES
PRIOR TO
RUNNING THE
INSTRUMENT
IMR02C15-E4 5-1
This chapter explains basic setup procedures prior to running the instrument.
5.1 Initial Setting...................................................................................5-3
Check the parameter related to the input .................................................5-3
Check the parameter related to the event ................................................5-4
Check the parameter related to the control action....................................5-5
5.2 Operation Setting ...........................................................................5-6
Set the control set value ...........................................................................5-6
Set the event set value .............................................................................5-7
5.3 Operation Start...............................................................................5-8
Change from STOP to RUN .....................................................................5-9
Tunes up PID parameters ......................................................................5-10
To Next Page
Loading...
